Renfert 2939 0000, Перевод оригинальной инструкции по эксплуатации

Страница: 36 / 303

EN
5.5.1 Audible Signal (Buzzer)
When the unit is switched on, various inputs are confirmed with an audible signal.
To change this:
⇒ Press operating mode key (21) for 3 sec�
♦ Start the programming mode�
⇒ Press operating mode key (21) again 1 x�
♦
T1a/T1b
T4 T2
LED1
T3
LED2 LED3 LED4
flashes
⇒ Press enter key (25)�
♦ Audible signal selected�
♦
T1a/T1b
T4
T2
LED1
T3
LED2 LED3 LED4
flashes: audible signal is switched on
♦
T1a/T1b
T4
T2
LED1
T3
LED2 LED3 LED4
off: audible signal is switched off
⇒ Switch the acoustic signal on or off with the suction performance key (23)�
⇒ Press enter key (25)�
♦ Save entry, exit programming mode�
5.5.2 Time interval for “full” indication for the dust drawer
After reaching a specifically set time interval, a message indicates the dust drawer should be emptied.
It is possible to select between 5 different times (factory setting is 50 hrs�)�
Time interval / hrs
Blink signal in the display
T1a/T1b
T4 T2
LED1
T3
LED2 LED3 LED4
2 1x
5 2x
10 3x
50 4x
100 5x
In the case of heavy dust generating devices (e.g. sandblasting units), the time interval for the
“empty dust drawer” indication should set to 5 hrs or if required 10 hrs.
To change:
Press operating mode key (21) for 3 sec�
♦ Start the programming mode�
⇒ Press operating mode key (21) again 2 x�
♦
T1a/T1b
T4 T2
LED1
T3
LED2 LED3 LED4
flashes.
⇒ Press enter key (25)�
♦ Select the time interval for “full” indication of dust drawer�
♦
T1a/T1b
T4 T2
LED1
T3
LED2 LED3 LED4
A blink signal is emitted according to the set time interval�
⇒ Change the time period with the extraction force -key (23)�
Each key press selects the next time interval� After 100 hrs it is possible to select 2 hrs again�
⇒ Press enter key (25)
♦ Save input, exit the programming mode�
21 23 25
Fig. 9
21 23 25
Fig. 10
- 11 -