R0E521000CPE00 User’s Manual
2. Setup
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 33 of 92
2.7.4 LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.14
shows the positions of the emulator status LEDs.
Figure 2.14 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.15 when the user system is not connected and as shown in Figure 2.16 when a
user system is connected.
After turning on the power, the LED4 (CLOCK) and LED5 (RESET) light on. Check the
target status LEDs display normally after starting up the emulator debugger.
When the target status LEDs do not display as shown in Figures 2.15 to 2.17, refer to “5. Troubleshooting” (page 84).
Figure 2.15 Target status LEDs display when the emulator starts up normally (when user system not connected)
MADE
POWER
SW1
COMPACT EMULATOR
IN
T
JP
1
5.
0V
JP
2
3.
3V
EX
T
CLOCK
RESET
RUN
LED3
LED6
LE
D5
L
E
D
4
POWER
LED1
SAFE
LED2
J1
J2
Target status LEDs
System status LEDs
POWER USB
5.0V
SYSTEM
STATUS
POWER
SAFE
POWER
CLOCK
RESET
RUN
TARGET
STATUS
COMPACT EMULATOR
R0E521000CPE00
-
+
MADE IN JAPAN
MCU
POW
E
R
5.0V
JP2
3.3V
EXT
JP1
INT
POWER
RESET
CLOCK
RUN
LED 3
LED5
LED4
LED6
When the user system NOT
connected:
The POWER LED does not light.
POWER
RESET
CLOCK
RUN
LED3
LED5
LED4
LED6
After turning the power ON.
: ON
: OFF
After starting up the
emulator debugger.
