R0E521000CPE00 User’s Manual
1. Outline
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 17 of 92
(3) System Reset Switch
By pressing the system reset switch, you can initialize the emulator system. Table 1.4 shows the functions of the system reset
switch depending on the state of the emulator.
Table 1.4 Functions of the system reset switch
State of Emulator
Function
When the user’s program is halted
Initializes the emulator and waits for a command from the
emulator debugger
When the user’s program is executed
Stops the user’s program, initializes the emulator, and
waits for a command from the emulator debugger.
IMPORTANT
Notes on a System Reset:
z
After pressing the system reset switch, restart the emulator debugger. Otherwise the display of emulator
debugger and the actual value (in the emulator) may not match.
z
When the emulator debugger does not start up normally even after rebooting, turn off the emulator and then turn
on again.
(4) Power Connector (J1)
This is a connector for connecting the power supply to this product. For details, refer to “2.5 Connecting the Power Supply for
the Emulator” (page 30).
(5) USB Cable Connector (J2)
This is a USB cable connector for connecting the host machine to this product. For details, “2.6 Connecting the Host Machine”
(page 31).
(6) MCU Power Supply Source Selection Jumper (JP1)/MCU Power Supply Voltage Selection Jumper (JP2)
These are the jumper switches to select power supply to the MCU and its power voltage. For details on these switches, see
“2.3.1 MCU Power Supply Source Selection Jumper/MCU Power Supply Voltage Selection Jumper” (page 22).
