Renesas M306K9T2-CPE, Руководство пользователя

Страница: 26 / 56

( 26 / 56 )
(3) LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is
enabled or not.
Figure 2.10 Positions of system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 of the system status LEDs is lit immediately after the power is activated.
If it is not lit, shut off the emulator and check the power supply for the emulator is properly
connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.11 when the target system is not connected and as
shown in Figure 2.12 when a target system is connected. For about 5 seconds after power is
turned on, all the target status LEDs light. After that, make sure the target status LEDs light
up normally.
If the target status LEDs do not light as shown in Figure 2.11 or Figure 2.12, see "5.1
Troubleshooting Until the Emulator Starts Up" (page 44).
Figure 2.11 LED display when the emulator starts up normally (target not connected)
Figure 2.12 LED display when the emulator starts up normally (target connected)
When the target system NOT connected:
The POWER LED does not light.
When the target system connected:
If the POWER LED does not light, shut off
the system and check the setting of the
jumper switches and if the power is properly
supplied to the target system.
POWER
CLOCK
RESET
RUN
LED3
LED4
LED5
LED6
: ON
: OFF
POWER
CLOCK
RESET
RUN
LED3
LED4
LED5
LED6
: ON
: OFF
MADE
POWER
SW1
COMPACT EMULATOR
CLOCK
RESET
RUN
LED3
LED6
LED5
LED4
POWER
LED1
SAFE
LED2
J1
J2
EXT
5.0V
INT
JP1
JP2
3.3V
Target status LED
System status LED