M3028BT2-CPE User’s Manual
2. Setup
REJ10J1457-0300 Rev.3.00 July 22, 2009
Page 27 of 90
2.6.5 LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.7
shows the positions of the emulator status LEDs.
MADE
POWER
SW1
COMPACT EMULATOR
IN
T
JP
1
5.
0V
JP
2
3.
3V
EXT
CLOCK
RESET
RUN
LED3
LED6
L
E
D5
L
E
D4
POWER
LED1
SAFE
LED2
J1
J2
Target status LEDs
System status LEDs
M3028BT2-CPE
POWER USB
5.0V
5.0V
3.3V
MCU
POW
E
R
EXT
INT
JP2
JP1
STATUS
SYSTEM
STATUS
TARGET
MADE IN JAPAN
COMPACT EMULATOR
POWER
SAFE
POWER
CLOCK
RESET
RUN
Figure 2.7 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.8 when the user system is not connected and as shown in Figure 2.9 when a user
system is connected.
When the target status LEDs do not display as shown in Figures 2.8 and 2.9, refer to “5. Troubleshooting” (page 82).
: ON
: OFF
POWER
RESET
CLOCK
RUN
LED3
LED5
LED4
LED6
When the user system NOT connected:
The POWER LED does not light.
After turning the power ON.
After starting up the emulator debugger.
POWER
RESET
CLOCK
RUN
LED3
LED5
LED4
LED6
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system not connected)
