M3028BT2-CPE User’s Manual
2. Setup
REJ10J1457-0300 Rev.3.00 July 22, 2009
Page 34 of 90
2.8.3 Connecting to a 64-pin 0.5mm pitch Foot Pattern
Here following is a procedure of connecting to a 64-pin 0.5mm pitch foot pattern on the user system using the M30291T-
64FPD (included with the M3028BT2-CPE-3). For details on the M30291T-64FPD, refer to its user's manual.
(1) Mount the NQPACK064SD-ND included with the M30291T-64FPD to the user system.
(2) Attach the YQPACK064SD included with the M30291T-64FPD to the NQPACK064SD-ND and secure it with the YQ-
GUIDE's.
(3) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M3028BT2-CPE.
(4) Attach the M30291T-64FPD to the YQPACK064SD.
●
: No. 1 pin
*: These products are included with the M30291T-64FPD package.
64-pin 0.5mm pitch
(64P6Q-A) foot pattern
YQ-GUIDE(×4) *
YQPACK064SD *
NQPACK064SD-ND *
HQPACK064SD
(not incluede)
MCU with on-chip
flash memory, etc.
(1)
(2)
(3)
(4)
M3028BT2-CPE
M30290T-PTCB *
M30291T-64FPD
M3
028
BT
2-C
PE
Figure 2.14 Connecting to a 64-pin 0.5mm pitch foot pattern
CAUTION
Notes on Connecting the User System:
z
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
IMPORTANT
Notes on Connectors of the Converter board:
z
The connectors of the M3028BT2-CPE and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
z
Between the M30291T-64FPD and YQPACK064SD are guaranteed for only 100 insertion/removal iterations.
