M3028BT2-CPE User’s Manual
2. Setup
REJ10J1457-0300 Rev.3.00 July 22, 2009
Page 21 of 90
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to “5. Troubleshooting” (page 82).
Check the package components.
Refer to “1.1 Package Components (page 14).
↓
User registration
Refer to “User Registration” (page 12).
↓
Install the included software, etc.
Install it from the included CD-ROM.
↓
Set the MCU power voltage
selection jumper (JP2).
Select a power voltage supplied to the target MCU.
↓
Connect the USB interface cable.
Connect the USB interface cable to the USB interface connector
(J2) of the emulator and the USB port of the host machine.
↓
Connect the power supply for the emulator.
Connect a power supply to the power connector (J1). Power supply
should be 5.0V ±5%, 2 A.
↓
Connect the user system.
Connect the user system as occasion demands.
↓
Turning on the power supply.
Turn on the power to the emulator and the user system as
simultaneously as possible.
↓
Check the LED display of the emulator.
Check that the system status LED, and POWER and RESET of
target status LED are lighting. When the user system is not
connected, the POWER of target status LED does not light up.
↓
Start up the emulator debugger.
Start up the emulator debugger.
↓
Set the operating environment
of the emulator debugger.
Set the INIT dialog box and MCU Setting dialog box of the
emulator debugger.
↓
Debug a program with various functions of
the emulator debugger.
For how to use the emulator debugger, refer to the online manual.
Figure 2.1 Flowchart of starting up the emulator
