8
0:00
18:40
Use the button when you want to modify the operational mode setting.
There are 5 modes available:
1.
“AUTO”: Automatic mode,
automatic selection of cooling or heating mode
2.
“COOL”: Cooling mode,
primarily used during the summer
3.
“DRY”: Dehumidification mode,
used in summer and winter
4.
“HEAT”: Heating mode,
primarily used during the winter
5.
“FAN”: Circulation mode,
no cooling or heating function
Mode button
Functional process
AUTO
COOL
DRY
HEAT
FAN
Set temperature is higher than
the room temperature
COOLING
or
HEATING
AUTO mode
To start Automatic mode, press the button once or several times until AUTO ap-
pears on the display.
In this mode, the control unit automatically selects the COOL or HEAT mode depending
on the temperature and maintains the set temperature. The FAN setting must also be
set to FAN AUTO.
Set temperature is below the
room temperature
AUTO
FAN
Functional process
Clock button
The time can be set by pressing and holding the button for two seconds. Pressing
and then releasing the buttons can perform the fine setting of the minutes and
when held down, the overall setting as long as the colon between the hours and min-
utes is blinking. The blinking stops when the program is transmitted by pressing the
button.
Functional process
0:00 18:40
0:01
Press and re-
lease button
Hold button
longer
.......
0:11
TIME
ADJUST button
The desired time can be programmed by pressing this button in the Clock, Timer On
and Timer OFF programs.
Functional process
0:00 0:01
Press and re-
lease button
Hold button
longer
0:11
Cancel button
A programmed on or off time can be reset by pressing the CANCEL button.
Functional process
OK button
The on or off programming can be transmitted to the air-conditioning unit by pressing
OK. The colon between the hours and minutes stops blinking.
22:30
0:10
.......
Functional process
