REMKO ATY 260, Операция и запасные части

Страница: 6 / 32

Operation
Infrared remote control
The infrared remote control
sends the programmed settings
in a distance of up to 6 m to
the receiver of the interior unit.
Uninterrupted receipt of data is
only possible if the remote control
is directed to the receiver and no
obstacles hinder the transfer.
First insert the supplied batteries
(2 each, Type AAA) into the
remote control. To do so, pull
off the flap of the battery
compartment and insert the
batteries correctly by polarization
(see marks).
The interior unit can be comfortably operated with the standard infrared remote control. The proper data transfer
is confirmed by the interior unit with a signal sound. If programming via the infrared remote control is not
possible, then the interior unit can also be operated manually.
Problems are shown in code
(see chapter Troubleshooting
and Customer service).
NOTE
Replace discharged batteries
immediately with a new set to
prevent battery leakage.
For longer down times, we
recommend removal of the
batteries.
NOTE
Display on interior unit
The display lights up according to the settings. In operation, the display
lights up, the selected mode and the nominal temperature are shown.
Manual operation
The interior unit can also be
operated manually. To do so, press
the button on the right side of
the unit to activate the automatic
mode.
In manual operation, the following
settings apply:
Automatic operation:
Above 21 °C = cooling operation,
set temperature 24 °C under
21 °C = heater operation, set
temperature 24 °C fan speed
AUTO
By pressing the button of the infra-
red remote control, the manual
operation is interrupted.
max. 6 m
1 Max. distance 6 m
Display on interior unit
Power
Unit turned on
Air circulation
mode set
Timer operation
Fan speed
Stage 1, 2 and 3 and
Auto (blinking)
Display
of coded error
messages, room
and nominal
temperature
C
TURBO
SET
Ion generator
turned on
REMKO ATY
6