Rema Tip Top PROMAXX 8150, Руководство оператора

Страница: 21 / 108

- E
nglIsh
- Operator’s manual 21
UNPaCKiNG / aSSEmBLY
WarNiNG
Take the utmost care when unpacking, assem-
bling, and setting up the machine as described
in this heading.
Failure to observe these instructions can lead
to damage to the machine and injury to the
operator or other persons.
- Remove the upper part of the packing and
make sure that the machine has not suffered
damage in transit; identify the points at
which the machine is anchored to the pallet
(Fig.1).
- The machine comprises three main sections
(Fig.1):
A cabinet
B tower
C air tank (FI version only)
- Once you have removed the tower (B) it is
advisable to set it in a horizontal position to
avoid the risk of it falling and getting dama -
ged.
assembling the tower
- Fit the tower into the threaded pins.
- Secure the tower to the cabinet with the nuts
and washers A (Fig. 2).
HoiSTiNG / moViNG
To remove the machine from the pallet, sling
it as shown in Figure 3.
This lifting point must be used whenever you
need to change the position of the machine.
Do not attempt to move the machine until it
has been disconnected from the electrical and
air networks.
iNSTaLLaTioN
CLEaraNCES
WarNiNG
Choose the place of installation in strict ob-
servance of local regulations regarding safety
in the workplace.
imPorTaNT: for correct, safe use of the equip-
ment, users must ensure a lighting level of at
least 300 lux in the place of use.
aTTENTioN
if the machine is to be installed outdoors,
it must be properly protected from adverse
weather by a roof.
Place the tyre changer in the designated work
position observing the minimum clearances
shown in Figure 4.
ambient conditions in the place of
operation
- Relative humidity from 30% to 95% without
condensation.
- Temperature range from 0∞C to 50∞C.
aTTENTioN
The machine must not be operated in poten-
tially explosive atmosphere.
ELECTriCaL aND
PNEUmaTiC HooK-UPS
WarNiNG
all operations required for the electrical
hook-up of the machine must be carried out
exclusively by a qualified electrician.
- The electrical supply must be suitably sized
in relation to:
• absorbed power specifications indicated on
the machine dataplate.
• the distance between the machine and the
power supply hook-up point, so that voltage
drops under full load do not exceed 4% (10%
in the case of start-up) below the rated
voltage specified on the dataplate.