Reloop DIGITAL JOCKEY 2, Инструкция по эксплуатации

Страница: 26 / 52

ENGLISH
26
B25. Loop Active display
If a loop is active this button will be illuminated.
Shift: FX Select (Advanced Mode). In Advanced Effect mode you can switch through the effects by
using this button. [Traktor PRO]
B26. Fx/Value 1-3 Encoder [Traktor PRO]
Depending on the selected effect it is possible to adjust the parameters 1-3 with this controller.
Shift: FX Select 1-3. In Chained Effect mode you can select the effects for banks 1-3 with the enco-
ders. [Traktor PRO]
B27. Activate 1-2 Buttons
Depending on the selected effect you can activate parameter 1 or 2 with these buttons.
B28. Activate 3 Button [Traktor PRO]
Depending on the selected effect you can activate parameter 3 with this button.
Shift: FX 1. With this functoin it is possible to assign and activate the effect bank for player A. [Trak-
tor PRO]
B29. Fx On Advanced Mode
By using this button in advanced effect mode you can activate the effect.
Shift: FX 2. With this function it is possible to assign and activate the effect bank for player B. [Trak-
tor PRO]
B30. dry/Wet Encoder
With the Dry/Wet encoder the effect rate can be faded in and out.
Shift: Loop +/-. By holding the shift button and simultaneously turning the Dry/Wet Encoder it is
possible to vary the Auto Loop bar length.
B31. Master Volume
With this controller the master and booth output volume can be adjusted (not individually adjustab-
le).
B32. Headphones Volume
With this controller the headphones‘ volume can be adjusted.
B33. Cue Mix Fading
With the Cue Mix controller you can simulate a pre-mix via the headphones. In the right position you
can hear the master signal and in the left position you can hear the cue signal.
B34. kensington Lock
Standardized connection for theft protection.
Front & Rear Panel
B35. 6.3 mm Microphone Jack
You can connect a microphone with a 6.3 mm jack to this input.
B36. Mic Volume knob
Via this knob it is possible to adjust the volume of a connected microphone.
B37. Mic Equalizer
Via this knob it is possible to adjust the sound characteristics of a connected microphone.
NOTE! The mic signal can be routed directly to the Audio Output (Master 1) and it is also func-
tional without the use of a software. The volume can only be adjusted if the Mic Routing Switch
-B57- is in the MST (Master) position.
B38. Headphones Connection
You can connect headphones with a 6.3 or 3.5 mm jack to these connections.
B39. Headphones Equalizer
With this equalizer it is possible to adjust the headphones‘ sound characteristics.
B40. Crossfader Curve
With this controller you can adjust the crossfading curve. The curve is steplessly adjustable from a
constantly increasing curve up to a hard adjustment.
NOTE! The adjustments of the crossfader curve are only applicable if the Phono/Line Routing
Switch -B48- is in the SW (Software) position.
B41. Mains Cord Strain Relief
With this the cord will be relieved from strain.