If the data to be duplicated (cloned) is NOT already
in a Transceiver, proceed as follows:
1. Connect the PM4500 to the Transceiver to be
programmed
using proper Start-up procedure.
2. Enter the data into the transceiver by using the
PM4500 normal programming functions.
3.
Press CLONE.
If “READ?” is in the display, press
ENTER.
If
not, press CLONE again and then
ENTER.
This will copy the Transceiver’s entire data into
the Programmer’s memory.
4. Turn OFF the Transceiver and then disconnect
the
5. Connect the PM4500 to a Transceiver to be
cloned,
using proper Start-up procedure.
6. Press CLONE (“WRITE?” must be in the dis-
play) and then
ENTER.
7. Repeat steps 4, 5 and 6 for all other Transceiv-
ers to be
cloned.
A detailed description of the
CLONE (READ
and
WRITE)
operations follows:
TRANSFERRING DATA
THE
PROGRAMMER (READ OPERATION)
1.
Press CLONE. Disolav will show:
NOTE:
If not,
2. Press ENTER (to answer Yes).
Processing will begin. During data transfer, the
display will show:
2 6
3. When transfer is complete, the display will
show:
TRANSFERRING DATA
THE
TRANSCEIVER (
OPERATION)
1. Press CLONE. Display
show:
Blinking
NOTE: If not, press CLONE again.
2. Press ENTER (to answer Yes).
Processing will begin. During data transfer, the
display will show:
NOTE: If you attempt to transfer SM (for example)
Series data in the Programmer to a different series
Radio (such as PT, RSP, etc.), the display will
show:
The Transceiver will emit a series of beeps and
no transfer will take place.
3. When transfer is complete, the display will show:
2 7
