6. a. Enter a single digit code corresponding to the
desired BCL status.
BCL No 0
BCL Yes 1
The display will show, for example:
Blinking
b. Enter a three-digit code corresponding to the
desired CTCSS Tone Code from Table 5 on
page 19 or DCS Code from Table 6 on pages
20 through 22. If you make an error in entering
the digits, press
DELETE
and start over.
NOTE:
External Decode is selected by enter-
ing 155 or higher (up to 169) for the RX Tone
Code. See Table 7 on page 23.
c.
Press
ENTER
to store the RX BCL and Tone
Code in the Transceiver’s memory and to
advance the display to
Transmit Frequency.
7. Transmit Frequency
Display will show, for VHF models, one of the
following:
Blinking
if previously programmed
Blinking
or, if none is programmed
1 6
For UHF models, the display will show one of the
following:
Blinking
if previously programmed
Blinking
or, if none is programmed
a. To program the channel for
Receive Only:
Press
DELETE.
The display will show the
following:
Blinking
Then press
ENTER
and go to Step 10 on page
18 to continue. See page 24 for the display
sequence of a Receive
Only
Channel.
b. To program the TX Frequency:
Enter the six digits of the desired TX frequency.
The valid frequency range is between 150 and
174 MHz for VHF models and between 450 and
462 MHz for UHF models.
Examples of keyed in frequencies:
54010 (154.010 MHz; VHF models)
171312 (171.3125 MHz; VHF models)
460775 (460.775 MHz; UHF models)
NOTE:
the decimal.1
If an error is made in entering the digits, press
DELETE
and start over.
1 7
