RELM GPH-CMD, Руководство по программированию, Страница: 9 / 61

RELM Wireless Corporation 5
group Password
ch 00
PRG
p 123456
PRG
After entering Programming Mode the
display will show ‘PRG CH 00.’
Press the [FCN] key.
The display will indicate the password for
the selected group.
If no change is needed for the group
password, press the [FCN] key to advance
to the next field.
To enter a new password, press the [CLR] key, then enter a new six-
digit password. Press the [ENT] key to store the new password and
advance to the next field.
Automatic Numeric Identification (ANI)
0000000
PRG ID
After the group password is set, the display
will indicate the ANI ID number (as many as
seven digits may be used). The ID number
can be used for either radio management or
transmitted as a DTMF tone burst for ANI purposes. The ANI can be
enabled or disabled. See “ANI/DTMF Mode” on page 10 of this
manual.
If no change is needed for the ID number, press the [FCN] key to
advance to the next field.
To enter a new number, press the [CLR] key and then the number
keys. The digits will appear at the right of display and move to the left.
Press the [ENT] key to store the new ID number and advance to the
next field.
transmitter time-out timer
After the ID number is set, the display will indicate ‘PRG TX.’ This
is the duration of the transmitter Time-Out Timer. 0 SEC means the
Time-Out Timer is disabled.
Press the [FCN] key to advance to the next field if no change is
needed.
225 sec
PRG TX
Press the [PRI] key to increase the Time-Out
Timer duration by 15 seconds, with a
maximum of 225 seconds (3 minutes, 45
seconds). Press the [PRI] key again to
change the duration from 225 seconds to 0.