10-5
2) Origin Point Input Logic Variable (CHn_ORG_POL@)
Set True when the origin point detector is the negative logic output (B contact) or the
origin point signal input is not used (constantly True).
3) Mark Signal Input Logic Variable (CHn_MARK_POL@)
Set True when the mark detector is the negative logic output (B contact) or the
negative logic should be internally used.
10.1.5 Input Selection Variables
The input selection variable is used to specify the combination of conditions to detect
edges to be captured against the origin point latch input and reference latch input.
1) Reference Latch Input Selection Variable (CHn_REF_SEL!)
This variable is used to specify input signals to detect edges that capture counters. The
condition is either rising or falling edge of either mark signal input or origin point signal
input of the corresponding group channels. The following table shows the list of conditions.
When the signal of the other channel is specified, the input logic of the signal is specified
by the input logic variable of the channel in which the signal is entered.
The two types of PG modules are MCIM-1 and MCIM-2. There are some restrictions in
setting the CHn_REF_SEL! of the MCIM-1 module.
Table 10-1 Reference Latch Input Selection Variable (CH1-3)
Variable
Conditions
0
Channel 1 (CH1) on rising edge
1
Channel 2 (CH2) on rising edge
2
Channel 3 (CH3) on rising edge
3
Channel 1 (CH1) origin point on rising edge
4
Channel 2 (CH2) origin point on rising edge
5
Channel 3 (CH3) origin point on rising edge
6
Channel 1 (CH1) mark signal on falling edge
7
Channel 2 (CH2) mark signal on falling edge
8
Channel 3 (CH3) mark signal on falling edge
9
Channel 1 (CH1) origin point on falling edge
10
Channel 2 (CH2) origin point on falling edge
11
Channel 3 (CH3) origin point on falling edge
12
Channel 4 (CH4) on rising edge (MCIM-2 only)
13
Channel 5 (CH5) on rising edge (MCIM-2 only)
14
Not available
15
Channel 4 (CH4) origin point on rising edge (MCIM-2 only)
16
Channel 5 (CH5) origin point on rising edge (MCIM-2 only)
17
Not available
18
Channel 4 (CH4) mark signal on falling edge (MCIM-2 only)
19
Channel 5 (CH5) mark signal on falling edge (MCIM-2 only)
20
Not available
21
Channel 4 (CH4) origin point on falling edge (MCIM-2 only)
22
Channel 5 (CH5) origin point on falling edge (MCIM-2 only)
23
Not available
Содержание PSC7000
