Reinke RPM Preferred, Руководство по эксплуатации

Страница: 28 / 64

18
Touch Screen User ' s Manual
7. Communication Settings:
Comm Setup
a. “Commun.”
Check the “Commun.” box to enable the communications or (COMM) tab.
b. “Communication”
Select the communication device that is installed from the drop down menu:
1. None( allows no remote access)
2. Phone Link (option #350955 system ID must be set to 001)
3. Remote PC (to use this selection the system must have the telemetry option installed also
requires software and radios provided by your local dealer)
4. Open Comm (allows communication between Touch Screen and another Reinke computer panel,
via radio signal, to send start, start/pump or stop commands to another system. Keep in
mind each system has to have a different ID # and if connecting to RAMS panel put a check
in the RAMS box see item “D”).
c. “Baud Rate”
Select the Baud Rate from the drop down menu: 1200, 2400, 4800, 9600 or 19200 (9600 is the
most standard) ensure that each communication device is set to same baud rate.
d. “Send Command”
Select a send command to send to the remote system then enter system number under pivot ID (this
is only allowed when using open comm selection).
e. “When this System”
Select the operations that will trigger the local system to send a command to the remote system.
f. “IP Password”
Further unlocks remote access features. Contact dealer for more information.
g. “ID”
Enter the local unique system ID here. The range available is 1-99.
h. “x10/GPS or EOS” Check Boxes
x10/GPS: Check box if using x10 relays and have the GPS & EOS working together.
EOS Remote: Check box to use GPS EOS relays. Required for zone VRI. This can be used as a
substitute for x10 relays
i. “RAMS”
Check the RAMS box if the remote system is a RAMS Panel.
b.
g.
f.
h.
I.
e.
a.
d.
c.
WITH TOUCH TECHNOLOGY
WITH TOUCH TECHNOLOGY