Reinco TM7-30 Series, Руководство по эксплуатации, частям и обслуживанию

Страница: 20 / 77

PAGE 18 REINCO TM7-30 SAFETY OPERATION PARTS AND SERVICE MANUAL
ENGINE OPERATING CAUTIONS
1
The engine has been set to a maximum operating speed of 2400 RPM. Do not exceed or set speed higher,
as wear from excessive vibration may occur.
2
Clean chaff from engine routinely. Partial engine cowl removal may be required on a periodic basis.
3
The engine is intended to run in a level position. Intermittently, the engine may run at a maximum of 25°
angle for not more than 10 minutes.
4
The available horsepower supplied by the engine drops 3% per one thousand feet above sea level. When
operating unit at an altitude of 5000 feet or greater, a high altitude carburetor jet must be installed.
Contact REINCO for details.
MULCHING
Your new Power Mulcher Model
TM7-30
will accept flakes or slabs of mulch for thrashing and blowing. The opening has been
limited to 8" in height to minimize potential overloading. A bale placed on the load tray must first be untied and the wire or twine
removed to prevent from being engorged by the machine. The placement operator simply separates a flake from the untied bale
and allows the blower suction to draw the mulch into the drum. An ideal flake thickness of dry mulch material is about 4 to 5
inches.
The
TM7-30
as equipped with standard flailing chain stations can blow mulch strands uniformly at distances 60 to 65 feet in
calm air. This may vary slightly depending on bale moisture content and the degree of decomposition.
This unit is rated at 5 tons per hour. Dry bales, with a count of 40 to the ton would require 200 bales for this coverage equating
to blowing ten bales every three minutes. Conversely, oversized or wet bales weighing as much as 100 pounds may require two
minutes or more for processing.
In practical terms, the machine can distribute mulch at higher outputs depending on the grade (quality), moisture content, and
age. "Clean" mulch will be thrashed and blown faster than will old, moldy or mulch infused with foreign objects. Similarly, hay
characteristically will not "mulch" as quickly as straw.
Every load of mulch varies one way or another and requires some human or mechanical adjustment. The machine is not
programmed to do this for you.
IMPORTANT ! IT IS IMPERATIVE THAT COMMON SENSE AND GOOD JUDGMENT BE
EMPLOYED WHEN OPERATING THIS MACHINE.
CAUTION ! BEFORE MULCHING, BE SURE TO READ THIS ENTIRE MANUAL.
A minimum crew of 2 men, not including the vehicle driver, is needed. To get maximum output perhaps as many as 4 or more
men will be required. Their function would be primarily to get the baled mulch to the machine and remove the twine or wire
wrap. While job size usually dictates labor requirements, a three member crew is common. This would include a vehicle driver,
a feed man and a placement operator. If extension hose is used, the operator would direct mulch placement at the far end of the
hose while the feeder would continuously provide a mulch supply to the TM7-30 thus reducing the crew size to two.
In the case of a three man crew, the operator normally stands next to the feed tray and flakes the supplied mulch bales off into
segments which are drawn into the beater chamber.
CAUTION ! NEVER FORCE ANY MATERIAL INTO THE MACHINE.
If mulch does not flow into the beater chamber by the air suction and a slight nudge, or if it plugs completely, stop the machine
before inspecting the beater chamber.
MANUAL 33000900 © REINCO INC. 1998 REVISED 3/98