Reinco TM7-30 Series, Руководство по эксплуатации, частям и обслуживанию

Страница: 13 / 77

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
SAFETY PAGE 11
LOOK THINGS OVER CAREFULLY
Before operating your Power Mulcher, look to see if your machine is in the proper condition. Are
the beater chains or flail knives all in place? Are they worn? Is the blower wheel in operating
condition? Is the work space clean? Is the fuel properly stored? Is all the bale twine cleaned up?
Are the machines guards and covers all in place? Are all nuts, bolts and screws tight? Do you know
where the fire extinguisher is? Do all workers have protective safety gear? Is everything in proper
operating condition? If not, report the unsafe condition to your supervisor and be sure the problem
is corrected before beginning operation.
KNOW YOUR MACHINE
Power Mulchers all have one characteristic in common. Once the beater shaft starts spinning, simply turning off the machine will
not stop the main shaft and blower wheel from spinning. The moving machinery can cause serious injury and even death. Be
aware that a shaft which rotates at more than 2000 revolutions per minute is extremely dangerous.
Before mulching, be sure to read this entire manual.
Do not operate unit if unfamiliar with operational and safety procedures on this or any unit.
The force from the blower can kick up dust and blow over small items that are not secure.
Never discharge the unit towards people. Bodily injury may occur.
Never force any material into the machine.
Never attempt to clear the beater drum of debris or make adjustments while the engine is running.
Be sure to keep all body parts and clothing away from moving parts while engine is running.
Do not attempt to discharge rocks, nails, or other debris which may damage blower or cause premature wear.
Do not operate machine without factory provided guards installed.
Twine or wire should be cut and removed to prevent loose trailing ends from being pulled into the beater chamber.
Do not allow fingers to become entangled in the bale twine.
Do not wear loose clothing which may become entangled with the machinery.
Do not add oil, water or fuel while engine is running or hot.
Do not perform maintenance while unit is running or battery is connected.
Do not under any condition operate the machine when vibrating.
Working space must be allowed not only for the boom operator, but also for access to the stacked mulch bales.
Daily, inspect the flailing chains, blower wheel blades and drive coupling assembly for signs of wear or misalignment.
Always make sure chain stations are replaced in matched pairs.
The flailing chains are made of case hardened steel. If a link breaks, an unbalance or vibration will occur. Do not under
any condition operate the machine when vibrating. Always make sure chain stations are replaced in matched pairs.
20
Check the leading edges of the blower wheel paddles. Dry mulch causes very little wear, but dirt laden, wet or moldy
material will abrade the leading edges of the paddles. When they begin to feather and bend back, replace the wheel.
Rocks and other foreign matter found in some mulch bales may also cause bending of the wheel blades which may
produce a noticeable vibration.
21
The drive coupling connects the engine to the blower shaft. Coupling misalignment will cause vibration. Realign
immediately should this occur.
22
Secure the discharge boom latch before transporting the machine.
23
The Power Mulcher is not a passenger vehicle. Never board the machine while moving from site to site.
24
Make sure all towing systems are operational and in good order.
25 Never attempt to hitch machine without using leveling jack.
26 It is imperative that common sense and good judgment be employed when operating this machine.
MANUAL 33000900 © REINCO INC. 1998 REVISED 3/98