Reinco TM7-30 Series, Руководство по эксплуатации, частям и обслуживанию

Страница: 16 / 77

PAGE 14 REINCO TM7-30 SAFETY OPERATION PARTS AND SERVICE MANUAL
MACHINE IN GENERAL
The
TM7-30
Series POWER MULCHER is a
self-contained, portable machine designed to thrash hay or
straw into short, uniform lengths and then blow the mulch
strands at distances up to 60 feet.
The Model TM7-30 is powered by a heavy duty, air
cooled, gas engine which drives an in line beater/blower
shaft. The engine, blower housing with lift ring, and beater
drum are mounted to a fabricated steel frame. A rectangular
discharge boom and elbow assembly are mounted to the
outlet side of the blower housing and allow the operator to
direct the placement of mulch.
Mulch is fed to the beater drum via a removable feed tray that can be folded for storage when the unit is in
transit. A bale placed on the load tray must first be untied and the wire or twine removed to prevent it from
being draw into the machine. Care should be used to avoid entangling one's fingers in the baling twine.
The opening from the load tray to the beater drum has purposely been limited in height to prevent overloading.
An ideal flake thickness of dry mulch material is about 4 to 5 inches.
Thrashing and debaling of the mulch flakes in the beater drum is accomplished by a series of beater chain stations. Air drawn into
the beater drum, by the blower, sucks the thrashed stalks and strands through the beater drum and convey them under high static
pressure and volume through the discharge boom.
An engine instrument control panel is mounted on the engine cowl. The panel includes ammeter, hour meter, keyed ignition, and
choke control.
Discharge distance is controlled by adjusting the engine speed with the throttle mounted within easy reach of the operator.
Model
TM7-30X
is a single axle, trailer mounted unit. It has a
fixed tongue, safety chains and top wind screw jack and foot
pad. A 2" ball type hitch is supplied standard. An optional
adjustable lunette eye hitch is also available. The skid and trailer
mounted units are similar with the exception of the discharge
boom length and the load tray assembly.
Either of the above models may be equipped with an optional
emulsion spray system which allows simultaneously blowing
hay and coating the mulch with emulsified asphalt or other
liquefied tacking material. Machines equipped with this option
are designated as
TM7-30A
or
TM7-30XA
.
UNPACKING
The
TM7-30
Series Power Mulcher is normally shipped unpacked on a flat bed truck. Some units, however are shipped
palletized or crated to accommodate other methods of transport. If it is received in the original factory packaging, your new
Power Mulcher Model
TM7-30
may require some light assembly.
1
Remove the banding straps by cutting with a pair of snips. Pull the cardboard from the pallet, and remove the outer
packaging.
2
Assemble the discharge boom assembly (Ref.: pg. 44 - 47).
3 Locate the lifting loop and lift the unit from the pallet with a hoist and sling.
4 Place the machine in an open area suitable for inspection.
MANUAL 33000900 © REINCO INC. 1998 REVISED 3/98