REID LIFTING PGR1TM20, Руководство по сборке и эксплуатации, Страница: 13 / 21

Trolley can be stored separately, on the
upper A-Frame or the leg
Never install winch bracket while gantry is under load.
Only install winches which are approved by REID for use
with the PORTA GANTRY RAPIDE and a suitable interface
/ mounting plate supplied.
Winch can be installed on both sides of gantry and on
either bolts A and B or B and C (PGR250-500) OR A and B,
B and C or A and D (PGR1000). Ensure winch bracket and
quick release knobs are hand tight.
A
A
C
C
D
B B
Ensure all ball lock pins are fully engaged
into their respective holes
Ensure all quick release knob/bolts on trap
Plates and beam are hand tight and secure
Ensure upright is bolted using top and
bottom fixing holes on trap plate
Ensure gantry is level
25
PORTA GANTRY
RAPIDE
To fold the gantry reverse steps 10 to 1 for
Standard Assembly or steps 17 to 13 for Confined
Space Assembly
When folding gantry ensure ball-lock pins are
stowed in cheek plate holes to avoid damage.
Gantry Stowage Trolley Storing Winch Bracket Installation
Remove existing bolt, A or C
Present bracket to gantry as shown (with locating pin at bottom) and insert new, longer bolts securing the winch
with the quick release knobs provided
PGR250-500 PGR1000
While in this vertical position remove ball lock pin
from its stow hole
Open leg and insert ball-lock pin into second
hole securing the leg in its open position.
Repeat for second leg
Repeat steps 13 to 16 for lower A-Frame
Rotate upper A-Frame around until ball-lock pin is
adjacent to beam
Remove pin and continue motion, follow steps
6 and 7
Be careful not to trap hands between beam and cheek plates!
Rotate upper A-Frame to vertical position
If fitted, ensure castor brakes applied before lifting a load.
Pre-lift checks
Confined Space Assembly
Assembly Instructions
18
19 19
14 15
16 17
13