Mounting the coupling
41
Mounting the coupling flange
To handle the coupling, follow the instructions on page 23.
Proceed as follows to mount the coupling flange (1) on the flywheel of the drive unit:
Make sure that the connecting surfaces are free of preservative and grease.
Lift the coupling flange in a suitable manner.
Align the bores of the coupling flange with the threaded bores in the flywheel.
Make sure that the coupling flange is seated in the centring of the flywheel and has
full-surface contact.
Insert the bolts (not included in the scope of supply) and tighten them hand-tight.
Use the provided washers in the case of aluminium flanges or when necessary5.
Tighten the bolts crosswise with the necessary torque, see page 44.
Mark the bolts which have been tightened to the required torque in colour.
Align the coupling as described from page 45.
Engage the two coupling halves as described from page 47.
