REHM INVERTIG.PRO digital 240 DC, 240 AC/DC, Руководство по эксплуатации

Страница: 59 / 88

Accessories and Options
59
4.2 Foot remote control P1 iSystem
With the foot remote control P1 iSystem (see Chapter 4.1
–
Overview) the
welding current can permanently be adapted during welding according to the
application task, using the foot pedal. The current set at the machine is the one
used when the pedal is pressed to the maximum. Based on tolerances of the foot
remote control in it´s initial range, the display value in the lower area can differ
from the welding current.
The foot remote control is connected to the 7-pin remote operation socket on the
rear of the INVERTIG.PRO
digital .
4.3 REHM TIG torch
The TIG torches (see Chapter 4.1.
–
Overview) are designed to work with the
electronic components of the INVERTIG.PRO digital . They offer a wide range of
options for setting the current source remotely (see Chapters 3.14.1, 3.14.2 and
3.14.3). The use of other TIG torches with remote control can lead to functional
disruptions or cause defects to the INVERTIG.PRO
digital .
CAUTION: When using TIG torches with remote control of any type not
specifically recommended by REHM, the guarantee claim is voided.
4.4 REHM water-cooling units TIG - COOL CART and
TIG - COOL
The REHM water cooling units TIG - COOL CART and TIG
–
COOL (see
Chapter 4.1
–
Overview) is designed, in terms of performance data and layout,
for the INVERTIG.PRO
digital
and allows you to use water-cooled TIG torches.
The water-cooling unit and the INVERTIG.PRO digital form a mobile unit, see the
operating instructions for the water-cooling unit (item number 730 1880).
4.5 Handheld remote control P2 12-pin (analog)
The handheld remote control P2 12-pin (analog) (see Chapter 4.1
–
Overview)
can be used to reduce the welding current set at the machine by between 0 %
and 100 %. This remote is suitable for MMA welding. This option cannot be used
for TIG welding as the torch button connector cannot be connected and thus it is
not possible to ignite the arc. Please note that the analogue input must be
activated in the system application in order to use the manual remote control.