Functional description
51
Torch poti-torch function
This setting is intended for the use of a torch with a potentiometer.
Inactive
→
Torch potentiometer is inactive, i.e. the potentiometer at the torch is not
evaluated
Active
→
Torch potentiometer is active, i.e. the value set at the potentiometer is
evaluated
Water cooling device
TIG COOL 1400
→
Welding with a water-cooled torch is possible without a water cooling
device being detected by the welding system, e.g.: TIG -COOL CART
1400, or other water cooling device without a communication interface.
TIG COOL 2000
→
Welding with water-cooled torch is only allowed if the wending system
detects the use of a functioning water cooling device, e.g. TIG-COOL
CART 2000. Otherwise an error message occurs, which prevents
damage to the welding torch if no water cooling device is present.
Classic application start current
Percentage or absolute
→
Start current is set percentage-wise to I1 or can be set to an absolute
value
Classic application end crater current
Percentage or absolute
→
End crater current is set percentage-wise to I1 or can be set to an
absolute value
Classic E-manual polarity function
Manual or auto (automatic changeover of torch connector polarity
–
depending on the selected electrode type): Note: The Auto function can only
be selected for INVERTIG.PRO
digital
AC/DC welding systems.
Mode sequence program function
Selection of "limiting" or "rolling" program sequence in the programs
application (Progr.). All programs within a folder belong to a program
sequence. The programs within this sequence can be loaded via the torch
Up/Down buttons. The type of loading can be "rolling" or "limiting".
Limiting
→
The loading of the programs within a program sequence ends with the
first or last program, i.e. no fast access is possible from the first to the
last program, because scrolling through is required at the end of the
program.
Rolling
→
The program in last position can be loaded immediately from the
program that is stored on first position (rotating).
Содержание INVERTIG.PRO digital 240 DC, 240 AC/DC
