installation
Grandview
®
G800C-1 Gas Fireplace | 63
Conversion from NG to LP (Part #761-977)
LP CONVERSION
G800C
1
11.02.20
920-183
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !
1.
Shut off the gas and electrical supply.
2. Remove the safety screen*.
3. Remove the glass door*.
4. Remove the logs, glass, and any other
media*.
5. Remove the two log supports* and log
grate assembly by removing 2 screws
and sliding the tray forward to remove.
*(See specific instructions in unit manual.)
Each Kit contains one LP Conversion Kit
Conversion Kit #761-977 Contains:
Qty. Part #
Description
1
904-947
Burner Orifice #53 LP
(PO5-12)
1
904-529
5/32" Allen Key
1
918-590
Decal "Converted
to LPG"
1
908-528
Red "LP" label
1
910-037
LP Injector (Pilot
Orifice)
1
920-183
Instruction Sheet
Installation of LP
Conversion Kit:
10. Re-install pilot cap and pilot retainer clip.
11. Remove burner orifice with a 3/8"
wrench. Use another wrench to hold on
to the elbow behind the orifice. Discard
orifice.
12. Reinstall new burner orifice LPG
stamped #53 and tighten.
7. Remove the pilot retainer clip below the
pilot cap.
9. Unscrew the pilot orifice with the Allen key;
then replace with the LPG pilot orifice,
provided in the kit.
Pilot retainer clip
8. Pull off the pilot cap to expose the pilot
orifice.
13. Turn control knob to the "OFF position.
Locate the Hi/Lo knob on the gas valve.
See diagram below.
Diagram 2: Slide burner assembly to the
right—then remove.
Diagram 1: Remove the left and right screws.
6. Remove three screws then remove the
burner assembly.
Fig. 1
15)
Insert a 5/32” or 4mm
Allen wrench into the
hexagonal key-way
of the screw (Fig.
2), rotate it counter-
clockwise until it is
free and extract it.
Fig.2
14)
Remove the
black protection
cap by hand from
the hi-low knob
(Fig.1).
Installer Notice:
These instructions must
remain with the appliance.
f i r e - p a r t s . c o m
