Regency Grandview G800C-1 Скачать руководство пользователя страница 6

Страница: 6 / 100

6 | Grandview

G800C-1 Gas Fireplace

owner's information

This is a copy of the label that accompanies each Grandview™ G800C-1 Direct Vent Gas Fireplace. We have printed a copy of the contents here for your review.

NOTE:

Regency

units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one.

For the State of Massachusetts, installation and
repair must be done by a plumber or gas fitter
licensed in the Commonwealth of Massachusetts.

For the State of Massachusetts, flexible connectors
shall not exceed 36 inches in length.

For the State of Massachusetts, the appliances
individual manual shut-off must be a t-handle
type valve.

The State of Massachusetts requires the
installation of a carbon monoxide alarm in
accordance with NFPA 720 and a CO alarm with
battery back up in the same room where the gas
appliance is installed.

Decal Location

DO NOT REMOVE DECAL FROM UNIT.

Remove bottom cover—decal will
be on the floor of the unit

DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE

563

DOOR SEAL: Please

check that the door is

properly sealed

FPI Fireplace Products International Ltd. Delta, BC, Canada

Minimum Clearances to Combustibles / Rear Vent—Clean Finish

Dégagements minimaux par rapport aux matériaux combustibles

Serial No./ No de série

920-421

Electrical supply/Alimentation électrique 115VAC, 1.5A, 60Hz.

NOT FOR USE WITH SOLID FUELS /

NE PAS UTILISER AVEC UN COMBUSTIBLE SOLIDE

Made in Canada/ Fabriqué au Canada

Duplicate S/N

0" Clearance to

combustibles from /

Top, sides, bottom and rear of unit

Mantel Clearances from

Fireplace Opening /

(A) 20-1/2" (521 mm) at max. depth

Side Wall Clearance

from Fireplace Opening /

B) Min. 26-1/2" (673mm)

(on one side)

Ceiling from Top of

Fireplace Opening:

C) Min. 36-1/2" (927 mm)

Mantel Depth:

D) Max. 19" (483 mm)

Alcove Clearances:

E) Min. Width 84" (2134 mm),

F) Max. Depth 36" (914 mm)

Minimum Vent Clearances:

Horizontal Top 2" (51 mm)

Horizontal Side 1-1/2" (38 mm)

Horizontal Bottom 1-1/2" (38 mm)

Vertical Vent 1-1/2" (38 mm)

(

See Instruction Manual for detailed instructions)

APPAREIL

FONCTIONNANT AU GAZ PROPANE

Modèle

-LP1

G800C

PROPANE GAS: Model G800C-LP1

NATURAL GAS: Model G800C-NG1

Minimum supply pressure

Manifold pressure high

Manifold pressure low

Orifice size

Minimum input

Maximum input

Altitude

Pression d'alimentation minimale

Pression manifold - haute

Pression manifold - basse

Taille de l'orifice

D bit calorifique minimal

D bit calorifique maximal

Altitude

5.0" WC/C.E. (1.25 kPa)

3.8" WC/C.E. (0.94 kPa)

1.1" WC/C.E. (0.27 kPa)

# 42 DMS

15,000 Btu/h (4.4 kW)

27,000 Btu/h (7.91 kW)

0-4500 ft/pi (0-1372 m)

Part #: 920-421

Colour: Everything black on grey except what is highlighted is printed red.

Size: File@100% 9.117’’W x 6.045’’H

Aug27/21 : Created Draft

Jan 25/2022: Added “Category I”

Printer

: Start serial sequence @ 000001

Pression d'alimentation minimale

Pression manifold - haute

Pression manifold - basse

Taille de l'orifice

D bit calorifique minimal

D bit calorifique maximal

Altitude

11" WC/C.E. (2.74 kPa)

10.5" WC/C.E. (2.61 kPa)

2.9"

WC/C.E. (0.72 kPa)

# 53 DMS

14,500 Btu/h (4.25 kW)

26,500 Btu/h (7.77 kW)

0-4500 ft/pi (0-1372 m)

Minimum supply pressure

Manifold pressure high

Manifold pressure low

Orifice size

Minimum input

Maximum input

Altitude

This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation Code, CSA B149.1.

This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the

United States, or when such a standard is not applicable, ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles

This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See

owner's manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used. (Kit #761-969). Fan Part # 761-917.

Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel Gas Code ou CSA-B149.1 en vigueur. Installer l'appareil

selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured Home Construction and Safety Standard. Si ces normes

ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles.

Cet appareil doit être utilisé uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U. seulement) installée à demeure

si les règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est

fournie.

This vented gas fireplace heater is not for use with air filters. Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.

FOR USE WITH GLASS DOORS CERTIFIED WITH THE APPLIANCE ONLY

POUR UTILISATION UNIQUEMENT AVEC LES PORTES EN VERRE CERTIFIÉES AVEC

L'APPAREIL

For Use Only with Barrier (Part #761-038/P )

Utiliser uniquement avec l’écran ( n ° 761-038/P )