Regency Excalibur
®
P90E-11 Direct Vent Gas Stove
| 59
maintenance
I
H
O L
F F O
N
O
OLI
T
P
TP
TH
THTP
Push Fan down
on mounting pins to reattach
I
H
O L
F F O
N
O
OLI
T
P
TP
TH
THTP
I
H
O L
F F O
N
O
OLI
T
P
TP
TH
THTP
Electrical
Receptacle
Outward
to remove
Ground Lug
Plug fan power cord
into
rear
receptacle.
5. To put fan assembly back into place, slip it
over the two mounting studs. Take care not to
damage the insulation on the fan base.
Ensure
that the fan blades do not rub against the
valve tubing. See Diagram 1.
Hint : Use a small amount of dish soap on the
pins as this will make it easier to slide fan back
into place.
6. Connect fan ground cable to ground lug and 2
wires removed from step 3. Ensure that there is
no interference with the wires when the louver is
closed and that no wire will touch the hot metal
surfaces or sharp edges.
7. Plug the fan power cord into the rear end of
the receptacle box to provide the maximum
clearance from the louvers. Ensure all wires are
neatly tucked away and away from the firebox
base.
Diagram 1
Fan Maintenance
To remove fan, follow steps below.
120 Volt AC power is needed for the fan. The fan
can be hard wired if desired. The outlet should be
installed in the receptacle box on the left hand side
by a qualified electrician. The neutral (wider) slot of
the polarized outlet should be at the top.
Unit must be grounded at all times. Do not cut the
ground terminal off under any circumstances.
To Install the Fan
1. Remove the bottom louver door.
2. Shut the power off by disconnecting 120 volt
power cord at receptacle.
3. Disconnect 2 wires at fan motor and ground
wire at ground lug.
4. Slide the fan in towards the front of the unit to
remove from fireplace.
IMPORTANT:
These fans collect a lot of dust from
within your home. Ensure you maintain
these fan motors on a regular basis by
vacuuming the fan blades and the hous-
ing with a soft brush nozzle.
Diagram 1
1. Shut off electrical and gas supply.
2. Remove arch surround and double doors (if
installed).
3. Remove glass door (refer to the glass door
installation section).
4. With the gas shut off, disconnect gas connection
at gas valve.
5. Remove the logs, media from the burner and
remove brick panels (if installed).
6. Remove the burner grate assembly by removing
the two (2) Phillips head screws (Diagram 1) and
then remove the base brick panel surrounding
the burner (Diagram 2), then slide the burner
assembly to the left and out.
To Remove Valve Assembly
Diagram 2
7. With the burner assembly out and put to one
side, disconnect the orange, green and yellow
wires from the valve.
Diagram 3
8. With the wires disconnected from the valve,
remove the heat shield on the IFC board by
removing two (2) Phillips head screws, then
slide the top of the heat shield out and away.
This will expose the IFC board.
9. Remove the spark electrode wire and flame
sensor wire from the IFC located at X2 and X3.
Diagram 4
Valve Assembly Maintenance
10. With the wires removed from the IFC board and
the valve, remove the rear log tray by removing
two (2) Phillips head screws.
Diagram 5
Diagram 6
