Regency City CV72E-LP11, Инструкция для владельца и по установке

Страница: 93 / 108

City Series CV72E
|
93
operating instructions
Aeration Adjustment
The burner aeration is factory set but may need adjusting due to either the
local gas supply or altitude. Open the air shutter for a blue flame or close for
a more yellow flame.
Note
: If the firebox glass, logs, inner panels, etc. are already installed, the
aeration can be adjusted from outside the firebox.
1. Remove the centre access panel on the outer trim, if finishing material is
already installed, remove the glass safety barrier and center outer panel--
see instructions in this manual.
2. Loosen 2 screws on the aeration lever access door. Lift the door up and
out to remove.
Remove
ttoooollttiipp
Aeration access door
3. Attach the handle to the aeration lever through the access opening--handle
will slide into position on the lever.
4. Adjust aeration accordingly.
Pushing lever in -- closes the air shutter.
Pulling the lever outward -- opens the air shutter.
Minimum Air Shutter Opening:
NG 3/16"
NG with Logs 3/16"
NG with Stones 3/16"
LP 3/8"
LP with Logs 3/8"
LP with Stones 3/8"
Note: Any damage due to carboning resulting from improperly setting the
aeration controls is NOT covered under warranty.
5. Remove the handle by lifting up and out--replace the access door and tighten
the 2 screws. Hang the handle back onto the magnet.
6. Reverse Step 1.
Aeration adjustment
handle
NOTE:
The aeration handle is located near the right hand side of the gas valve
access door -- attached by a magnet.
Aeration adjustment video