Regency City CV72E-LP11, Инструкция для владельца и по установке

Страница: 28 / 108

28
|
City Series CV72E
installer's information
Top rear standoffs
Unit Assembly Prior to Installation
Before you Start - Removing the Unit from the Pallet
Side Standoff Assembly CV72E
The CV72E has 4 standoffs, 2 on each side that need assembly before installing.
The standoffs are shipped in a flat position -- fold the standoff and install the
standoff onto the unit by sliding the 2 tabs into the slots on the unit. Bend the
tabs to secure. Secure opposite end of the standoff with one screw.
Rear Standoffs
The 8 rear standoffs are already attached to the appliance. Do not remove
these standoffs. The 2 top rear standoffs are designed so that screws can be
used to secure the appliance to the rear wall if needed. Studs must be in this
location if choosing to screw this into studs.
Leveling legs
Leveling Legs
There are four levelling legs - two on each side that can be adjusted (with the
supplied tool--found in the manual package) if required.
tooltip
Remove the screws securing the unit to the pallet
Due to the size and weight (529 pounds shipping weight) of the CV72E--lifting
and moving the unit will require 4 people.
Place a length (long enough to get a solid grip on each side) of 2 x 4 under
the handle on each side.
Lift and move the unit carefully.
Note : When in position, the handles may be removed from the unit by removing
6 screws on each handle. Ensure that when the handles are removed that the
screws are put back into place in all 12 holes locations where the handle had
been previously (6 per side). The handles can be recycled.
standoffs
tooltip