6
|
Regency
®
CLASSIC™ C34E-11 Direct Vent Freestanding Gas Stove
safety decal
This is a copy of the label that accompanies
each CLASSIC Direct Vent Freestanding Gas
Stove. We have printed a copy of the contents
here for your review. The safety label is located
on the back panel.
NOTE:
Regency
®
units are constantly being
improved. Check the label on the unit and if
there is a difference, the label on the unit is
the correct one.
P
L
5" WC (1.25kpa)
3.5" WC (0.87kpa)
1.6" WC (0.40kpa)
#36 (2.71mm)
21,000 Btu/h (6.15 kw/h)
32,000 Btu/h (9.38 kw/h)
0-4500 ft/pi (0-1372m)
NATURAL GAS STOVE:
Model C34E-NG11
L
Minimum supply pressure
Manifold pressure high
Manifold pressure low
Orifice size
Minimum input
Maximum input
Altitude
APPAREIL FONCTIONNANT AU GAZ NATUREL
Modèle C34E-NG11
Pression d'alimentation minimale
Pression
lev e
manifold é é
Pression manifold basse
Taille de l’orifice
D bit calorifique minimale
é
D bit calorifique maximale
é
Altitude
Model/Modèle :
C34E-NG11
DOOR SEAL:
Please check that the door is properly sealed.
MAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE
518
DUPLICATE SERIAL NO.
FPI Fireplace Products International Ltd.
Delta, BC, Canada
Made in Canada/ Fabriqué au Canada
Minimum Clearances to Combustibles /
Dégagements minimaux
par rapport aux matériaux combustibles
A 10"/250mm
B 6"/150mm
E 1.5"/38mm
Minimum ceiling height from
top of unit:36"/914mm
Minimum plafond hauteur en
haut de l'appareil: 36"/914mm
Minimum clearance to vent 1.25“/32mm
Serial No./ No de série
Part #: 920-060
Colour: Black on Grey except selected text is in red as per this print.
Size:
Printed at 100% - 10
Material: 2 ml silver matt polyester (DPM SMS)
Feb. 08/19: Created decal
Apr. 29/19: Rev. A - Updated efficiences
Back wall
Side wall E
A
A
B
Back wall
Side wall
Side wall
This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation
Code, CSA B149.1.
This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280, in the United States, or when such a standard is not applicable, ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations
Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where
not prohibited by local codes. See owner's manual for details. Optional Fan Kit (Part # 494-917)
Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel Gas Code ou CSA-B149.1
en vigueur.
Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured
Home Construction and Safety Standard. Si ces normes ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations
Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles.
Cet appareil doit être utilisé uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U.
seulement) installée à demeure si les règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil ne peut pas être utilisé avec
d'autres gaz sauf si une trousse de conversion certifiée est fournie.
This vented gas fireplace heater is not for use with air filters. Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.
For use with glass doors certified with the appliance only Pour utilisation uniquement avec les portes vitrées certifiées avec l'appareil
518
VENTED GAS FIREPLACE HEATER - NOT FOR USE WITH SOLID FUELS.
NE PAS UTILISER AVEC DU COMBUSTIBLE SOLIDE.
FOYER AU GAZ À ÉVACUATION -
C#4001172
For Use Only with Barrier (Part # 493-005) Follow installation instructions. À utiliser uniquement avec l’écran ( n ° 493-005) Suivre les instructions d'installation.
ELECTRICAL SUPPLY/ALIMENTATION ÉLECTRIQUE:
115V_60HZ less than/moins de 2 AMP
P
L
11" WC (2.74 kpa)
10" WC (2.49 kpa)
6.4" WC (1.59 kpa)
#52 (1.61mm)
23,000 Btu/h (6.74 kw/h)
29,000 Btu/h (8.50 kw/h)
0-4500 ft/pi (0-1372m)
PROPANE GAS STOVE:
Model C34E-LP11
L
Minimum supply pressure
Manifold pressure high
Manifold pressure low
Orifice size
Minimum input
Maximum input
Altitude
APPAREIL FONCTIONNANT AU PROPANE
Modèle C34E-LP11
Pression d'alimentation minimale
Pression
lev e
manifold é é
Pression manifold basse
Taille de l’orifice
D bit calorifique minimale
é
D bit calorifique maximale
é
Altitude
Model/Modèle :
C34E-LP11
Listed:
VENTED GAS FIREPLACE HEATER/FOYER AU GAZ À ÉVACUATION
Certified to
/Certifi
:
ANSI Z21.88-2017 • CSA 2.33-2017 /
é
CSA 2.17-2017
Refer to Intertek's Directory of Building Products for detailed information.
Pour plus de détails, se reporter au Répertoire des produits de construction de Intertek.
920-060a
CSA P.4.1 Fireplace Efficiency (FE) /Efficacité énergétique des foyers (EEF) CSA P.4.1
Natural Gas / Gaz naturel 64.89%
Propane Gas / Gaz propane 65.82%
CANADIAN ENERGY
PERFORMANCE
VERIFIED
RENDEMENT
ÉNERGÉTIQUE
VÉRIFIÉ
EP5011169
For the State of Massachusetts, installation
and repair must be done by a plumber or
gas fitter licensed in the Commonwealth of
Massachusetts.
For the State of Massachusetts, flexible con-
nectors shall not exceed 36 inches in length.
For the State of Massachusetts, the appli-
ances individual manual shut-off must be a
t-handle type valve.
The State of Massachusetts requires the
installation of a carbon monoxide alarm in
accordance with NFPA 720 and a CO alarm
with battery back up in the same room where
the gas appliance is installed.
DECAL LOCATION
When locating the rating plate on the C34 the rat-
ing plate will be located at the back of the stove
on the right hand side of the unit. (See Image)
DO NOT REMOVE DECAL FROM UNIT.
