Regency Fireplace Products CF780, Инструкция для владельца и по установке

Страница: 14 / 56

Flooring Requirements
Before installing your CF780, make sure the floor surface and floor structure
can sustain the weight of the complete fireplace and whatever finishing material
you will use to cover the facing of your fireplace.
You can install your fireplace at the floor level or build a platform to elevate
it to the desired height. Again, make sure the platform is level and built to
sustain the weight of the fireplace and finishing material you will use to finish
the facing of your fireplace.
Note:
If the appliance has 3-1/2" of non combustible material under the full
width and depth of the fireplace, the bottom standoff is not required.
Combustible Floor: Bottom standoff
If the CF780 is installed on any type of combustible floor surface or structure,
you
MUST install the fireplace onto the fireplace bottom standoff provided with
the fireplace. You must also reinforce the sub-floor to help spread the load from
the legs of the bottom standoff throughout the floor structure to prevent sagging.
2. Determine location , level the unit, and secure to the floor.
1. Assemble the bottom standoff shield to both supports (see Diagrams below)
using eight large self-tapping screws.
0.500
Diagram 2 - Positioning the Fireplace Bottom Standoff
Diagram 1 - Installing the Fireplace Bottom Standoff
3. Position the bottom standoff on the floor along with the spark guard (refer
to the “Hearth Extension” section for additional information). Use Diagram 2
to help in properly locating the bottom standoff and the spark guard based
on the silhouette of the entire fireplace which includes the back and angled
sides’ standoffs.
tooltip
Diagram 3
Anti-Tip Stability Bracket Installation
4. Using at least 1-½" wood screws (not provided), solidly attach both left
and right sides of bottom standoff to the floor, as well as the front and back
of the inner sides, as shown in Diagram 3. If possible, attach the bottom
standoff to the floor joists below using 3" wood screws (not provided).
5. Install the fireplace onto the fireplace bottom standoff making sure that
the base of the fireplace is aligned with the bottom standoff as shown in
Diagrams 1 and 2.
tooltip
14
|
CF780 Wood Fireplace
installation