Regency Fireplace Products Alterra CS1205, Инструкция для владельца и по установке

Страница: 63 / 80

Regency CS1205 Freestanding Wood Stove
| 23
installation
1) Remove the five screws from the back panel of the unit - to remove the
fan cover plate.
2) Slide the fan up into the rear heat shield.
3) After aligning holes, secure the fan to the rear heat shield using the five
screws removed earlier.
4) Secure the bottom of the fan using the two fan clips (in manual package)
and two bottom screws removed in step 1.
Note: The connection cord should not be in contact with any hot
surfaces.
Read the operating instructions for the fan before using.
5) Plug fan into a properly grounded three prong receptacle.
Ground
Fan Fan
Ground
Green
Neutral
Live
Whit
e
Fan
Switch
Manual/
Auto
Switch
Black Black
High
(Black)
Low
(Red)
Black
Fan Thermodisc
(normally open)
120V AC
60 Hz
Blower/Fan Wiring Diagram
Wire98gr.eps
updated Jan. 27/00
updated: Aug. 09/05
capitalized the word Nut
Lockwasher
Ground wire
from power cord
Ground wire
from fan
#8 Groun Lug d
Star washer
Nut
Nut
Star washer
Grounding
Lug Detail
CAUTION : Label all wires prior to disconnection
when servicing controls. Wiring errors can cause
improper and dangerous operation.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged
(grounding) plug for your protection against shock
hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
NOTE: This appliance, when installed,
must be electrically grounded in accord-
ance with local codes or, in the absence
of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian
Electrical code, CSA C22.1.
Automatic
To operate the fan automatically, push the bottom switch on the side of the fan housing to "AUTO" and the top switch to either "HIGH" or "LOW" for fan speed.
This will allow the fan to turn on as the stove has come up to operating temperature. It will also shut the fan system off after the fire has gone out and the
unit cooled to below a useful heat output range.
Manual
To manually operate the fan system push the bottom switch to "MAN" and the top switch to either "HIGH" or "LOW". This will bypass the sensing device and
allow full control of the fan.
Switching from "AUTO" to "MAN" or "HIGH" to "LOW" may be done anytime.
FAN OPERATION
FAN WIRING
BLOWER/FAN INSTALLATION
Remove back panel Install fan - under rear
heat shield