Regency Fireplace Products 686-927, Инструкция для владельца и по установке

Страница: 91 / 128

City Series CB60EPV
|
91
maintenance
920-179 10.31.19
2
CITY SERIES 60
16. Reinstall pilot cap and pilot retainer clip.
17. Prior to installing burner—adjust aerations settings - to 3/8" for LP. Re-
install burner (see Step 11).
18. Make sure aeration cap tab is inserted into the slot on the bracket. Adjust
aeration handle if necessary.
14. Remove pilot retainer clip with pliers and pull off the pilot cap to expose
the pilot orifice.
15. Unscrew the pilot orifice with the Allen key; then replace with the LPG
pilot orifice and the pilot cap, provided in the kit.
Installer Notice:
These instructions must be left
with the appliance
.
Pilot retainer clip
13. Remove burner orifice with a 3/8" wrench. Use another wrench to hold
on to the elbow behind the orifice. Discard orifice. Reinstall new burner
orifice LPG stamped #50 and tighten.
tooltip
Burner Orifice
Location
12. Loosen 8 screws in locations shown below (4 at front and 4 at rear)—
slide burner to the left away from the orifice and lift out.
Burner screw locations
Slide burner to the left and lift out
City Series
LP SYSTEM DATA
Min. Supply Pressure 11" WC (2.73kpa)
Manifold Pressure - High 10.5" WC (2.62 kpa)
Manifold Pressure - Low 2.9" WC (0.72 kpa)
Orifice Size #50 DMS
Maximum Input 36,000 Btu/h (10.54 kW)
Minimum Input 19,500 Btu/h (5.71 kW)
Altitude 0-4500 ft (0-1372m)
tooltip
tooltip
CB60E shown
CB60E shown
CB60E shown
19. Reverse steps 1 to 11.
20. Ensure the pilot lilght is in the correct orientation to the burner. Recon-
nect the gas and electrical supplies. Start the appliance (see section
on Lighting Instructions). Ensure that pilot and burner ignition are com-
pleted without delay. Check inlet and outlet pressures at full load. With
a soapy solution, leak test the entire system. Verify correct flame and
pilot appearance.
21. See Gas Pipe Pressure Testing in manual.
Slot on bracket
Aeration cap tab
aeration
handle