Regada REMATIC ULR 1PA-Ex, Инструкции по установке, обслуживанию и техническому обслуживанию, Страница: 36 / 52

34 ULR 1PA-Ex, ULR 2PA-Ex
Table 5 setting error flags and warning flags as at the delivery
PARAMETER ERROR WARNING
ESD X
Analog Input X
Wrong command X
Torque X
Torque check X
Torque calibration X
Regulator calibration X
Stroke (turns sum) X
Wrong position X
Spin X
Spin direction X
RAM X
ROM X
EEPROM X
Bus X
I2C X
Reset X
V5V X
Parameters X
Set mode X
Relay X
Temperature < X
Temperature > X
Phase X
Power frequency X
Thermal fuse X
Manual control X
Position module X
Position module type X
Position sensor 1 X
Position sensor 2 X
Position sensor 3 X
Position sensor 4 X
Torque module X
Torque module type X
Torque sensor X
LED module X
LED module type X
LCD module X
LCD module type X
Power Supply/Relay module X
Power Supply/Relay module type X
Notes: X – the error or warning flag is activated.
With the error flag , the EA takes the positron defined for the FAILURE REACTION function
eventually stops (depending on the kind of the error), and it will not operate until the error is removed.
With the
warning flag , the EA continues in operation.
The user is advised on error or warning through the READY relay (according to the relay setting), by
LED ERROR blinking on Control unit, by ERROR message on LED or LCD display, eventually
through the program after connecting the EA with a PC
Note 1 : In some cases having the error removed the electric actuator must be restarted by switching-off the
voltage supply to the electric actuator for about 3 sec.
For repairing eventually the electronics use the fuse – see Fig.2 (F3) for example SHURTER MSF
250, or sub miniature SIBA 164550 xxx (see chapter 2.2.2), which is located on source board.