Regada REMATIC ULR 1PA-Ex, Инструкции по установке, обслуживанию и техническому обслуживанию, Страница: 28 / 52

26 ULR 1PA-Ex, ULR 2PA-Ex
4.2
Procedure for setting individual parameters and the register of errors and
warnings
- is given in the separate attachment 74 1053 02 resp. 74 1076 02 of these operating instructions.
The factory default setting of individual programmes shown in Table 3 and Table 4, as long as otherwise
specified by the customer:
Table 3
Factory default settings of individual parameters in version without local control; possibility to set-up
by operating the control unite buttons.
For the individual parameters set-up see appendix 74 1053 02
MENU NAME FACTORY SETTING-UP
1 TORQUE 100% of value shown on nameplate for OPEN & CLOSE direction.
2 END LIMIT
- C = Po O = Position - end position switching closed and
open from position if valve type is not specified
- C = O = Position - closed in end by thrust position
and end position switching open from position for single-seat
valves
- C = O = Torque – switching in both end positions by
thrust for double-seat valves
3 TORQUE BLOCKING
- 2 sec. blocking time
- 5% blocking position for OPEN & CLOSE direction
4 RELAY READY
- errors (READY COM-NO relay contacts closed in error free
conditions)
5 RELAY 1...RE5
- position O for relay R1
- position C for relay R2
- from position 95% for relay RE3
- from position 5% for relay RE4
- disabled for RE5 relay
6 CPT (output signal) 4 to 20 mA
REGULATION – (according to
specification)
2P 3P
7
ANALOG INPUT - 4 to 20 mA (2 to 10 V)
8 DEAD ZONE - 3 %
9 FAILURE REACTION STOP
Other parameters set-up is possible to change only by using the PC software
TITLE FACTORY SETTING-UP
DIRECTION OF ROTATION clockwise
THERMOSTAT TEMPERATURE 25 °(space heater OFF temperature)
INTERNAL DEAD ZONE 2 % (only for 3P)
Safe position 0 %
FUNCTION I1
ESD
ACTIVE I1 high level
FUNCTION I2 DISABLED
ACTIVE I2 high level
THERMAL FUSE FAILURE
functionless with this EA type
THERMAL FUSE RESET functionless with this EA type
CYCLE MODE DISABLED
CYCLE RUNNING TIME 10 s
CYCLE PAUSE
50 s
CYCLE POSITION O1 0 %
CYCLE POSITION O2 100 %
CYCLE POSITION C1 0 %
CYCLE POSITION C2 100 %
O AND C TOLERANCE 1 %
CREATE BACKUP START
RESTORE FROM BACKUP START
RESTORE FACTORY SETUP
START
ACTIVE ERRORS CLEAR