Reely EP Buggy Ranger Brushless 4WD RtR, Руководство пользователя, Страница: 46 / 107

43
• Function #8, green LED flashes 1x long, 3x short: Neutral range (for neutral setting on transmitter)
This function allows the range or area "D" (see picture right) is
recognised as the neutral position by the transmitter.
A = middle lever (10) position
B = Full forward
C = Full reverse
D = Neutral range
E = Forwards range
F = Reverse range
Settable values are 6%, 9% and 12% of the lever travel, the factory
setting is "9%".
• Function #9, green LED flashes 1x long, 4x short: Timing (only for sensorless motors)
The manufacturer has set the timing to "15.00" befitting the motor. You should not adjust this value. In principle,
higher values can lead to better output performance from the motor, yet also to lower efficiency (shorter drive time).
Settable values are 0.00, 3.75, 7.50, 11.25, 15.00 , 18.75, 22.50 and 26.25, see the preceding table in this chapter.
• Function #10, green LED flashes 2x long: Motor type selection
This option is factory set to "Brushless-Motor" and cannot be adjusted.
• Function #11, green LED flashes 2x long, 1x short: Overheating protection
The overheating protection of the drive control unit activates at +95°C, if this temperature is measured for longer
than 5 seconds. In this case the motor is switched off and the green LED flashes.
For safety reasons, we recommend you always activate the overheating protection.
When switched off, the drive control unit can be destroyed by overheating, you will void your guarantee!
A
B
C
D
E
F