REED 00 C50SS, Руководство пользователя, Страница: 21 / 84

REED
00 MODEL:
C50SS
TRAILER CONCRETE PUMP
OPER.
PAGE 20
When you have completed the above checks, the unit is ready for start up.
•
At the main control panel, turn key switch and start engine. When engine starts,
release key.
•
Check the engine indicator lights of alternator, oil temperature, low coolant and low
oil.
•
Check that CONTROL LOCATION switch is in LOCAL position.
•
Allow a few minutes for engine to warm up.
•
Increase engine RPM by adjusting THROTTLE control to desired engine speed as
indicated on tachometer.
•
Check the swing tube pressure gauge (3000 PSI/210 BAR gauge) that it is
operational. Gauge should read approximately 2000 PSI (140 BAR).
•
Pressure gauge (6000 PSI/420 BAR) will only indicate pressure when pump switch
is ON .
•
DO NOT CYCLE PUMP unless water or material has been placed in the hopper.
•
To cycle pump adjust THROTTLE and VOLUME control to desired setting.
•
Place pump switch to ON position. The hydraulic drive and material cylinders will
now cycle.
•
Turn pump switch OFF to stop cycling.
At START-UP, ALWAYS OPERATE AT LOW SPEED
AND LOW VOLUME until proper operation has been
assured.
REVISION: