PowerLift
by ReechCraft
24
Once the Walk-Around Inspection check is complete, perform a function check
of all systems in an area free of overhead and ground level obstructions.
IF THE MACHINE DOES NOT OPERATE PROPERLY, SHUT OFF AND REMOVE
POWER FROM THE MACHINE IMMEDIATELY! REPORT THE PROBLEM TO THE
PROPER MAINTENANCE PERSONNEL AND DO NOT OPERATE THE MACHINE
UNTIL IT HAS BEEN DEEMED SAFE FOR OPERATION.
Function Check Items
1. Drive Shaft Brake
- Check to be sure the input hex shaft plunges
properly and returns to it’s properly seated position. The input hex
shaft should be firmly seated in its return position and resist turning
freely in either direction.
2. Overload Clutch
- Check to be sure the Overload Clutch is
functioning properly by briefly running the drill motor in the reverse
direction (counterclockwise). You should hear and audible buzzing
sound.
NOTE:
Be sure to maintain a firm grip on the drill.
3. Outrigger Interlock
- Check to be sure the Outrigger Interlock
is functioning properly by briefly running the drill motor in the
forward position (clockwise) with the outriggers removed. The
platform should not disengage from is fully lowered position and
you should hear an audible “buzzing” sound coming from the
overload clutch slipping.
NOTE:
Be sure to maintain a firm grip on the drill.
4. Mast Connectors
- Check to be sure the components of the Mast
Connectors are present, undamaged, clear of debris and in good
working condition. (See Figure 2-7)
NOTE:
Be sure the top mast
Termination Plate is present, undamaged and securely attached to
the mast section.
SECTI
ON
2
PREPARATION & INSPECTION
2.4
Function Check
DANGER
NOTICE
CAUTION
WARNING
