12
REDWING RC 50CC EXTRA
•Next, locate the tail wheel hardware.
•The parts will assemble as laid out below - -
•Install the tailwheel bushing to the carbon
fiber mount. Then install the wheel to the wire
using the wheel collar and then secure the
assembly using the upper retainer.
From the Pro:
File a flat spot for the wheel collar on
the wire and use medium thread locking compound
to install the setscrews.
•Next install
the tiller pin
into the
rudder. Drill
a 1/8” hole in
the bottom
of the rudder
4.5" back
from hinge
line. Clean the tiller pin with alcohol and coat
inside of the hole in the rudder 15 min epoxy
and insert the knurled end of the pin fully.
•Line up the carbon fiber tailwheel bracket to
the fuse and mark for the 3 mounting screws.
Use a 1/16” drill bit to pre-drill the holes. Then
thread a mounting screw in and out of each
hole and apply 2 drops of thin CA to each. Allow
the CA to soak in and fully cure before installing
the tailwheel bracket to the fuse.
•Install the tiller wire (bend as shown above)
and tighten the setscrew using medium thread
locking compound.
