Tail Wheel Assembly
All parts for the tail wheel
•
Locate the hard block on the bottom of the
rudder and drill a 1/8 inch pilot hole and enlarge
to 7/32 inch for the steering tube
◦
DO NOT glue at this time until tail wheel is
installed and completed
•
Assembled tail wheel parts
•
Assemble the tail wheel using a 10mm socket
and a 7/16 inch wrench and tighten to the
carbon fiber tail wheel mount
•
Use the tail wheel bracket as a template, center the
bracket, mark and pre drill holes using a 1/16 inch
drill bit for the mounting screws
