RedMax GZ7100, Руководство по ремонту

Страница: 23 / 52

ELECTRICAL SYSTEM
English – 23
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Replacing the generator
1. Before the generator can be replaced, the following
components must be removed:
A. Recoil starter.
B. Flywheel.
C. Silencer.
D. Carburettor.
E. Cylinder.
2. Detach the carburettor space bottom plate by
removing the four bolts. See fi g. 13.
3. Detach the generator by removing the three fi xing
bolts. See fi g. 14.
4. Disconnect the lead from the on/off switch and lift out
the
generator.
5. Locate the new generator as shown in fi g. 14 and
tighten the bolts to 4 Nm.
6. Position the lead as shown in fi g. 15 and reconnect it
to the on/off switch.
7. Fit the carburettor space bottom plate with the four
bolts. See fi g. 13. Ensure that the lead is seated in
the recess in the plate as shown in fi g. 15.
Tighten the bolts to 5 Nm.
8. Refi t the components from point 1.
Replacing the heating element in the rear hand grip
(tank unit).
1. Disconnect the two cable clips beside the springs.
2. Remove the fi ve bolts which secure the front hand grip.
3. Fit the new hand grip and replace the fi ve fi xing bolts,
tightening them to 4 Nm.
4. Reconnect the two leads.
Replacing the front hand grip
1. Before the rear hand grip element can be replaced
the following components must be removed:
A. Tank unit.
B. Throttle lock and throttle lever.
2. Disconnect the leads, remove the bolts as shown in
fi g. 16 and remove the heating element.
3. Insert the new heating element, replace the bolts as
shown in fi g. 16 and reconnect the cables.
4. Refi t the components from point 1.
Replacing the on/off switch
1. Remove the on/off switch and disconnect the leads.
See
fi g. 8.
2. Connect the leads to a new switch and press it into
place.