RedMax GZ7100, Руководство по ремонту, Страница: 21 / 52

ELECTRICAL SYSTEM
English – 21
Fig. 5
Fig. 6
Fig. 7
H
0,3 mm
B
B G
G
E
Reassembly
Assemble the ignition system as follows:
1. Locate the fl ywheel on the crankshaft. Turn it gently
until the key on the fl ywheel mates with the recess in
the shaft.
2. Fit the fl ywheel washer and nut. Tighten the nut to 35
Nm. See fi g. 5.
3. Locate the ignition module (B) without tightening the
bolts.
4. Rotate the fl ywheel so that the magnet (G) is beside
the ignition module. See fi g. 6.
5. Insert the feeler gauge (H) (0.3 mm) into the air gap
between the ignition module and fl ywheel magnet.
The clearance applies only to the two lower pegs on
the ignition module. See fi gs. 6 and 7.
6. Push the ignition module towards the fl ywheel and
tighten the bolts to 4 Nm.
7. Fit the cable guide (D) and press in the HT lead into
place. Remove the piston stop and connect the HT
lead to the spark plug.
8. Pull out the blue lead, thread it under the HT lead
at F and push home the cable clip onto the ignition
module. See fi g. 1.
9. Press the blue lead into the groove in the cable
guide. See fi g. 1.
10. Attach the pawls (E) for the recoil starter. See fi g. 1.
11. Attach the cylinder cover and the recoil starter
assembly. See page 17.
Stop switch
The stop switch is described in the section ”Safety
equipment”. See page 14.