RedMax GZ7100, Руководство по ремонту

Страница: 38 / 52

TANK UNIT
36 – English
Fig. 1
Fig. 2
Fig. 3
F
Tank unit
!
WARNING!
The fuel that is used in the chainsaw
poses the following hazards:
1. The fl uid and its fumes are poisonous.
2. Can cause skin irritation.
3. Is highly infl ammable.
Dismantling
1. Run off the fuel from the tank.
2. Remove the cylinder cover, chain and guide bar.
3. Disconnect the throttle cable (A) from the carburettor
and push out the cable outer from its location. See
fi g. 1.
4. Remove the fuel line (B) from the carburettor.
5. If the saw is equipped with heated hand grips,
disconnect the lead at C.
6. Remove the bolts (C and D) and the travel limiter
bolt (E) on the clutch side. See fi g. 2.
7. Remove the bolt (F) from the fl ywheel side. See fi g. 3.
8. Lift the motor unit slightly and, using pliers, push off
the cable clips from their respective switches. If the
saw is equipped with hand grip heating, disconnect
the leads from on/off switch.
9. Lift the motor unit and turn the tank unit slightly to
the flywheel side so that the fixed travel limiter
comes free. Lift off the tank unit.
10. If necessary, detach the front hand grip from the tank
unit.
11. If necessary, lift out the fuel pipe and pull off the fuel
fi lter. Use tool 502 50 83-01.
12.If the chainsaw is equipped with hand grip heating,
detach the connector to the heating element in the
rear hand grip. See pages 20 and 21.
13. If the springs are to be removed, refer to AV-system.
NOTE!
Take care that the fuel pipe and throttle cable
are not damaged.