40
“RESET”
Keypad Switch
RESET
is used to re-initiate purge operation following a purge fault condition (see FAULT
INDICATION page 46).
RESET
is also used to reset the Interval log.
“STATUS”
Keypad Switch
Allows operator to display the current purge unit operating mode. The “
STATUS
” keypad
switch can also be used as the exit key for LOGs, CLEAR LOGs, and SENSORS display.
“<“or“>“
CURSOR MOVEMENT
Keypad Switches
The cursor keypad switches are used to move the cursor left or right when se tting certain
function parameters such as;
“SET CLOCK”
and
“SETTINGS”.
The “<“and “>“ switches
are also used to scroll through the HISTORICAL LOGs.
Informational Displays
The informational displays are viewed by pressing these keypad switches:
STATUS Display
LOGs Display
SENSOR Display
Certain other miscellaneous displays will appear (such as fault warning, drain delays etc.)
when and if they occur. See pages 44, 45 and 46 for further information.
STATUS Display
The “
STATUS
” keypad switch allows the operator to view current purge unit operational
status. After viewing alternate displays, such as LOGs and SENSORS, the STATUS keypad is
used to return to the current operating mode display. The purge unit will automatically return
to the system status display when there has been no keypad activity for a period of 5 minutes,
except when in the diagnostic mode.
When the Purge is not in one of the three operational modes the display will read.
Displayed:
System Ready
Select Mode
Alternating with
System is Ready
00:00
(current time)
Содержание Redi-Purge PRG-113-C3
Страница 2: ...2 Revised Technically as of October 11 2013 1994 REDI CONTROLS INC GREENWOOD INDIANA...
Страница 4: ...4...
Страница 67: ...67...