Redi Controls Redi-Purge PRG-113-C3, Инструкция по установке, эксплуатации и обслуживанию, Страница: 24 / 68

24
6
QUICK START
6
- OPERATION
NOTE: If your chiller has been down for repair or has a lot of air in it you may wish to read the
service tips starting on page 58 before commencing purge operation.
Quick Start Introduction
This procedure can only be used if you have properly installed the purge unit and have completed
the
PRELIMINARY CHECK OUT AND POWER UP starting on page 15. The Quick Start
instructions are designed to allow the purge operator to get the purge unit operational in as little
time as possible. The Quick Start instructions utilize the factory preset default operating
parameters shown at the end of the quick start instructions.
NOTE: If you do not feel comfortable using the Quick Start, skip this section and familiarize
yourself with the rest of the manual, then return to this section.
The LCD display should read:
System Ready
Select Mode
alternating with:
System Ready
00:00 AM
(clock display)
NOTE : Upon initial power-up purge display may read BATTERY FAULT PRESS RESET
KEY . Press RESET keypad switch to reset unit and begin QUICK START program.
1.
Press “SET CLOCK” Keypad Switch
Display changes to:
Set CLK 00:00 AM
use < >, 0 - 9
The display reads “00:00” which stands for Hours:Minutes. The underline is the cursor, to set the
clock, use the cursor movement (“<“ and “>“) keypad switches to move the cursor beneath the
appropriate position you wish to change. To change the setting use the
numbered keypad
switches. To change between AM and PM move cursor beneath A or P and press any numbered
keypad switch. Once the correct time has been set, you must PRESS the “ENTER” keypad switch
TO ENTER NEW SETTING.
Display changes to:
System ready
Select Mode
alternating with:
System Ready
EXAMPLE:
07:13 AM
(time just set)