Redi Controls Redi-Purge PRG-113-C3, Инструкция по установке, эксплуатации и обслуживанию, Страница: 39 / 68

39
To advance to next Log press “ SCROLL ”
To exit “
LOGs ” display press “ STATUS ”
Log 11 -
Interval Log - Total chiller run time since log last reset.
This log is provided to help the operator track desired service intervals, such as chiller run
time since last oil change, or run time hours until next refrigerant analysis, etc..
Displayed:
Interval LOG H:M
Day 00 00000:00
(hours:minutes)
The “
Interval Log ” can only be reset by pressing the “ RESET ” Keypad
Switch while viewing the Interval LOGs.
To return to “
Log 1 ” press “ SCROLL ”
To exit “
LOGs ” display press “ STATUS ”
“CLEAR LOGs”
Keypad Switch
This switch is used to zero out data from certain LOGs. To use the “ CLEAR LOGs ” keypad
switch the “Security Lock” must be deactivated (see Dip switch S1 Security Lock page 28).
Displayed:
30 Day history
will be Deleted
Alternating with
Press RESET to
Clear LOGS
After the
RESET key has been pressed the display will read:
LOGs are Cleared
NOTE: The CLEAR LOGs function does not reset the compressor run time or the Cumulative
pumpout time since this data has a significant historical value for purge and chiller
analysis. Also the interval log will not be cleared (see interval LOGs above).
To exit “CLEAR LOGs” press “STATUS” switch.
Be sure to enable Security Lock . Switch
Dip switch S1-position 4 to the “OFF” position.