Redexim Turf Tidy 2300, Руководство пользователя и каталог запчастей

Страница: 25 / 34

25
14.2 CHANGING / REPLACING BLADES
The blades have to be exchanged if the blades are worn or another type of blade is required;
this takes place according to the following procedure
(See fig.14)
:
!! It is recommended that all blades are replaced in relation to potential
imbalance in the rotor !!
!! Ensure that the Turf Tidy / tractor combination is properly blocked and
cannot move independently !!
!! Ensure that the PTO shaft on the Turf Tidy has been disconnected !!
1. Remove the securing pin 1 and clip on both sides.
2. Activate the hydraulic outlet of the tractor to raise and tilt the collection tray.
3. Block the collection tray from tilting by placing the securing pin 1 on both sides through the
hole 2 in the collection tray and tube and securing it with the clip.
!! Ensure that the blocking hook 10 is inside the tube !!
!! Ensure that the Turf Tidy is properly blocked and cannot move
independently !!
4. Remove bolts 3 from the rear hatch 4.
5. Raise the rear hatch 4 and secure using the hooks 5.
6. Remove the clip 6 from the brackets 7 and remove the brackets from the rotor together with
the blades 8 and blades with integrated tips 9.
!! Take care! The blades may be sharp !!
A number of brackets are fitted close to the side plates of the head, the cover
plate 11 can be moved for the removal of these.
!! After fitting the blades, return the cover plate 11 to the original position so
that the hole in the side plate is covered !!
7. Replace the blades 8 and /or the blades with integrated tips 9 and place the bracket 7 with
the blades back onto the rotor and secure this using the clip 6.
See fig. 15 for the correct position of the brackets and blades.
The direction of the bracket opening corresponds to the number on the rotor.
!! Do not use flail blades 9 if blades with integrated tips are used for mowing !!
8. Close the rear hatch 4 after the blades have been replaced and secure using the bolts 3.
!! Beware of jamming hazard when closing the rear hatch !!
9. Remove the securing pins 1 on both sides and lower the collection tray by operating the
hydraulic output of the tractor.
10. Insert the securing pin into the hole 12 on both sides and secure using the clip.