Redexim Turf Tidy 2300, Руководство пользователя и каталог запчастей

Страница: 17 / 34

17
9.2 ADJUSTING WORKING DEPTH USING THE FRONT WHEELS
Proceed as follows to adjust the working depth:
(See Fig.10)
5
3
4
2
1
Fig. 10
1. Fully lift the head by operating the hydraulic output of the tractor and ensure that it is
properly positioned in the transport securing device 1 and is fully blocked to prevent
sagging.
!! NEVER CRAWL UNDERNEATH THE MACHINE !!
Switch the tractor off and apply the parking brake.
Ensure that the machine is properly blocked and cannot move independently.
If wind vanes (See fig. 9 item 4) have been fitted, never increase the depth to
ensure that the wind vanes remain above the surface.
!! If this is not observed, the surface and the machine can be seriously
damaged!!
!! Adjust the working depth carefully; if the setting is too deep the machine
and the surface can be seriously damaged !!
2. Remove clip 2 and remove the wheels 3 by sliding them downwards.
3. Adjust to the required height by using various combinations of spacing rings.
4. Slide the wheels 3 back into the centre pin 5 and secure using the clip 2.
5.
(See Fig.9)
Loosen the bolts 2 on both sides of the machine and adjust the rear roller using
nuts 3 until the distance above the ground A is 10mm (0.4") and align on both sides.
Use the indicator stickers on the spindles for this.
This prevents the grass layer being removed by the head.
6.
(See Fig.9)
Secure the nuts 3 and bolts 2 properly.
7. Run a test strip to verify that the correct working depth has been achieved.