Redexim Rink DS3100CB, Руководство по эксплуатации

Страница: 7 / 28

SERVICE
Attaching and detaching
- Coupling (1) a towing vehicle. To do this, loosen the screws of the coupling (1), adjust to
the correct height and tighten the screws. (See page 1)
- Fully crank up the jockey wheel (2), then loosen the jockey wheel clamp and pull the
jockey wheel up as far as possible and clamp. (See page 1)
- Couple DS3100CB RINK disc spreader to towing vehicle.
- Check PTO shaft (3) for length, shorten if necessary and place on the tractor PTO shaft.
Secure against the attached chain against twisting. (See page 1)
- Connect the power (4) to the operating power of the towing vehicle. The indicator light
(green) lights up when engaging the POWER switch on the control panel.
(see Fig. 1 and page 10 - Fig. 2)
- Attach bracket (5) for the control panel in a suitable position on the towing vehicle (see
Fig. 1).
- When using a hydraulic brake axle
#
(see page 27 - Fig. 13), connect the brake line
plug to the corresponding control unit circuit of the towing vehicle and open the ball
valve. The brake is applied when operating the control unit on the towing vehicle. If the
machine is shut down while the brake is applied, the ball valve of the brake line must be
closed before disconnecting the plug.
- For the lighting system
#
(see page 26 - Fig. 12). Attach the seven-pin plug of the
lighting system to the towing vehicle.
Fig.1: Coupling
All lines are assembled in such a way that they do not touch the ground
or rub against the towing vehicle.
Couple in reverse!
Depressurise hydraulics to towing vehicle before coupling.
2
4
3
1
5