Redexim Rink DS3100CB, Руководство по эксплуатации

Страница: 3 / 28

SAFETY REGULATIONS
 The DS3100CB RINK disc spreader is built exclusively for spreading fine-grained, loose
grit such as sand, trickle, granules or the like.
 Any other use shall be deemed improper use. The manufacturer shall not be liable for
any damage resulting. The user alone bears the risk.
 Proper use also includes compliance with the operating, maintenance and service
conditions prescribed by the manufacturer.
 The DS3100CB RINK disc spreader is state-of-the-art and reliable; however, the RINK
DS3100CB disk spreader may pose a risk to life and limb of the user and strangers
unless used, maintained or repaired by persons familiar with and aware of the dangers.
 Every person who is responsible for the operation, maintenance and repair of the
spreader must have read and understood the operating instructions and in particular the
chapter on safety regulations .

For repairs only use original spare parts from the manufacturer .
 In addition to the instructions in this operating manual, the general safety and accident
prevention regulations must be observed.

When using public roads, the respective provisions (StVZO) apply.
 Giving other people a ride is not allowed!
 Climbing onto the loading bridge is prohibited while the spreader is in use . A note
is attached to the wheel cover on both sides of the DS3100CB RINK disc spreader .
This note must always be easy to read and must be replaced if damaged.
 The user must inspect the DS3100CB RINK disc spreader for visible damage and
defects before use. Modifications to the DS3100CB RINK disc spreader (including
operation), that may negatively affect safety, must be eliminated immediately. For safety
reasons, no modifications to the
DS700CB RINK disc spreader (with the exception of
modifications/additions approved by the manufacturer) may be made to the machine. If
modifications are made to the
DS700CB RINK disc spreader , the current CE of the
machine will become invalid and must be renewed by the person who made these
modifications.