Redemac Autolabel D43, Руководство пользователя

Страница: 22 / 38

Definition of the drawing:
1. Service Lever
2. Belt
3. Print Roll
Follow these steps to change the Print Roll and Belt:
1. Remove the large front cover on the right of the machine. It is at the same end as the Print
Roll. It shall be pulled from the machine, and it is only attached by friction. There are grooved
surfaces for better traction.
2. Near the Belt there is a small black Service Lever (part 1 above) that must be pushed to
the end position at the same time as the Printhead Handle is moved to the service position
(marked by a wrench on the front of the machine).
3. Remove the Belt from the geared Print Roll wheel.
4. Pull out the Print Roll.
5. Remove the Belt from the geared motor wheel.
6. Place the new Belt around the geared motor wheel. Check that the Belt is not on top of the
motor wheel side walls.
7. Push in the new Print Roll.
8. Place the Belt around of the geared Print Roll wheel.
9. Move the Printhead Handle in the closed position.
WARNING: The motor will start to turn automatically! Keep away from moving parts!
10. Check that the Belt moves smoothly during the adjustment cycle.
11. Push the front cover back onto the machine.
22
www.redemac.com 888-335-9570